Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Gauge or instrument faultWarning lightLeakNoiseCorrosion or rustAir conditioning or heaterMisfire or rough idleLoss of engine power, no acceleration

Possible causes

Electrical, wiring and power, 2005178 records
Instruments and lighting
Audio and telematics
Engine
Electrical, wiring and power
Heating and air conditioning
Brakes
26Instrument panel cluster gauges stick, flutter or stop working3Shift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-0552Speedometer needle appears inaccurate (specification +/- 2 MPH)1Voltmeter fluctuates between 12 and 14 volts (Regulated Voltage Control, normal)3OnStar System: software, failed2OnStar cannot configure the vehicle (118 error) after the 15-08-44-001 upgrade1Some OnStar features no longer work (2G cellular sunset; the module is not broken)1Red OnStar LED and DTC B2455 after Canada upgrade bulletin 15-08-44-001 (audio and microphone drain wires shorted)1OnStar Hardware: software2Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring1Coil Harness: design or manufacturing1Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion1DRLs or auto headlamps will not disable with the headlamp switch (Canada, RPO Z49; normal)1Intermittent stall, misfire or crank no start (Ignition 1 feed wire broken near C148/C149)1Vehicle Communication Interface Module: electrical fault1Rear Window Defroster Contact: broken1HVAC blower motor resistor module / connector overheating1Climate Control Module: software1Seat Heater: overheated1ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement
2 causes not drawn
Causes with no correction stated (10)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Electrical, wiring and power
Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (2)Cable: overheated (1)Fuse: failed (1)Horn: failed (1)
Heating and air conditioning
HVAC temperature doors default to full hot or defrost cannot be obtained (1)
Airbags and seat belts
Airbag Sensor: failed (1)
Body, doors and interior
Horn Pad: failed (1)Keypad: failed (1)Rear Wiper: failed (1)Seat Position Sensor: broken (1)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Electrical, wiring and power, 2005

Candidate cause (the documents say what to do)

Vehicle Communication Interface Module: electrical fault

1 of the records matching this search name this component as the cause.

How to tell

B2455

What to do

No technical document states a check or a repair.

In the records

  • Vehicle Communication Interface Module: repaired 1
See the evidence (0 technical documents, 1 records)

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.