Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:Misfire or rough idleWarning light

P050D is written only in documents for GM vehicles in general. No record or document that names this vehicle states it, and it may not be a code this model year and engine set. The records are shown as their sources write them.

Record by record

7 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Read the records one by one (1)

ENGINE1

  1. Manufacturer communication2000–2006 GMC YUKON ・ 2023-09-18(6 earlier editions of this document folded here)

    Misfire and DTC Codes Diagnostic Information

    1. 1Fault

      • With DTC P0300 - P0308 and/or P050D, use GDS and save the freeze frame records.

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. Perform the relative compression test in the PICO NVH or Oscilloscope software; SI Document number 5518386 covers the procedure.
      2. If it passes the relative compression test, the concern is an ignition or fuel delivery issue.
      3. Check the ignition supply voltage to the ignition module/coil assemblies and also to the fuel injectors.
      4. Inspect the spark plugs for anything abnormal.
      5. Note the fuel trim values and on which bank, and compare actual MAF with calculated air flow.
      2 more points

    3. 3Correction

      Caution

      • The injector balance procedure in GDS is only a preliminary test and its results should not decide injector replacement, especially with a low or no flow injector.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：All brands and models with gas engines, model years 2000 - 2024.
    • Condition：With DTC P0300 - P0308 and/or P050D, use GDS and save the freeze frame records.
    • Confirm：Perform the relative compression test in the PICO NVH or Oscilloscope software; SI Document number 5518386 covers the procedure.
    • Confirm：If it passes the relative compression test, the concern is an ignition or fuel delivery issue.
    • Confirm：Check the ignition supply voltage to the ignition module/coil assemblies and also to the fuel injectors.
    • Confirm：Inspect the spark plugs for anything abnormal.
    • Caution：The injector balance procedure in GDS is only a preliminary test and its results should not decide injector replacement, especially with a low or no flow injector.
    • Confirm：Note the fuel trim values and on which bank, and compare actual MAF with calculated air flow.
    • Confirm：Check for a possible fuel quality issue, especially with a cold engine hard start and/or a misfire on all cylinders.
    • Confirm：Confirm whether a crankshaft variation learn has been completed and whether there is any abnormal engine noise possibly related to the misfire.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This Preliminary information communicates information that will need to be provided to TAC to aid in diagnosing if a vehicle comes in with misfire and DTC Codes P0300 - P0308 and/or P050D

Showing 1 of the 7 you can open. Narrow the search to see the rest.