Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning lightReduced brakingNoiseABS activates (at low speed and the like)Corrosion or rustSeat beltSmoke or fireAir bag did not deploy

Record by record

3 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Symptom

Component named as the cause

Work done

How it is said to have ended

  • says it came back1

A ribbon is as wide as the records that state both of its ends (only the commonest are drawn). A record that names several symptoms or components runs through each. Orange is records that say the fault came back or was not fixed. Results come from owners’ reports only; one that does not say is “result not stated”. None of this is a likelihood of a cause or a rate at which work succeeds.

Read the records one by one (3)

Known issuesAftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1061

  1. Recall2000–2006 GMC YUKON ・ —

    Wheel Hub Assembly Bearing Nut Loosening Recall

    1. 1Fault

      • The inboard retention nut that maintains the hub bearing assembly can loosen, resulting in an ABS light indication, noise, and/or wheel separation from the vehicle; wheel separation can result in a vehicle crash.

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. On 2x4 vehicles, raise the vehicle on an approved hoist first; the hub assembly is good if a yellow, green or blue paint mark is seen on the grease cap on the inboard side of the steering knuckle.
      2. If the paint mark is not present, remove the wheel and the brake rotor and clean rust from the hub assembly face to check for the date code stamping.
      3. Defective hub assemblies can be identified by the country of origin on the package together with a recalled date code, by the date code on the package, or by the date code on the hub assembly.
      4. If a round yellow sticker is present on the box label, the part is good.

    3. 3Correction

      Repair

      1. The hub assemblies were manufactured for aftermarket use; owners of these parts should have them removed and replaced as soon as possible.
      2. Federal-Mogul will replace the recalled hub assemblies free of charge.

      Parts

      • The recalled part numbers are 515020, 515021, 515025, 515053, 515054, 515059 and 515060.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：This is an equipment recall by Federal-Mogul of certain wheel hub assemblies sold as replacement parts only.
    • Applies to：The recalled hub assemblies were packaged and sold between January 23, 2006 and December 20, 2007 under the National and CARQUEST Premium (BGS/Blue) brands, in 7 base part numbers.
    • Parts：The recalled part numbers are 515020, 515021, 515025, 515053, 515054, 515059 and 515060.
    • Applies to：The application lists include GMC 1500 Yukon (2WD) and GMC 1500 Yukon XL (2WD), 2001-2006.
    • Applies to：ILJIN manufactured the recalled hub assemblies from December 27, 2005 to November 29, 2007.
    • Condition：The inboard retention nut that maintains the hub bearing assembly can loosen, resulting in an ABS light indication, noise, and/or wheel separation from the vehicle; wheel separation can result in a vehicle crash.
    • Confirm：On 2x4 vehicles, raise the vehicle on an approved hoist first; the hub assembly is good if a yellow, green or blue paint mark is seen on the grease cap on the inboard side of the steering knuckle.
    • Confirm：If the paint mark is not present, remove the wheel and the brake rotor and clean rust from the hub assembly face to check for the date code stamping.
    • Confirm：Defective hub assemblies can be identified by the country of origin on the package together with a recalled date code, by the date code on the package, or by the date code on the hub assembly.
    • Confirm：If a round yellow sticker is present on the box label, the part is good.
    • Repair：The hub assemblies were manufactured for aftermarket use; owners of these parts should have them removed and replaced as soon as possible.
    • Repair：Federal-Mogul will replace the recalled hub assemblies free of charge.
    Cause
    CERTAIN FEDERAL-MOGUL REPLACEMENT WHEEL HUB ASSEMBLIES WITH THE BRAND NAMES: NATIONAL, CARQUEST P/NOS. 515020, 515021, 515025, 515053, 515054, 515059, AND 515060, SHIPPED BETWEEN JANUARY 23, 2006, AND DECEMBER 20, 2007, SOLD FOR LIGHT DUTY AND MEDIUM DUTY TRUCKS. THE INBOARD RETENTION NUT USED TO MAINTAIN HUB BEARING ASSEMBLY CAN LOOSEN RESULTING IN AN ABS LIGHT INDICATION, NOISE, AND/OR WHEEL SEPARATION.
    Remedy
    FEDERAL-MOGUL WILL NOTIFY CUSTOMERS AND WILL REPLACE THE HUB ASSEMBLY FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 7, 2008. OWNERS CAN CONTACT FEDERAL-MOGUL TOLL-FREE AT 877-489-6659.
    Consequence
    WHEEL SEPARATION CAN RESULT IN A VEHICLE CRASH.

ELECTRONIC STABILITY CONTROL (ESC)1

  1. Owner complaint2001 GMC YUKON ・ 2014-11-16

    ABS light and grinding noise from pump, recurring failures

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

    Read the sentences of the record
    Fault
    IN AUG 2005, THE ABS LIGHT ON OUR 2001 GMC YUKON WITH 51K MILES (= 82,077 km) CAME ON AND THERE WAS A GRINDING NOISE (THE PUMP) UNDERNEATH THE DRIVER'S SIDE WHICH REMAINS ON WHEN THE VEHICLE IS TURNED OFF.
    Remedy
    THE ABS FUSE MUST BE REMOVED TO SHUT OFF THE PUMP.

SERVICE BRAKES, HYDRAULIC1

  1. Owner complaint2001 GMC YUKON ・ 2005-09-29

    ABS light on and ABS motor running continuously while driving

    1. 1Fault

    2. 2Finding the cause

    3. 3Correction

      THE MECHANIC UNHOOKED THE ABS MOTOR.

    Read the sentences of the record
    Fault
    DT: WHILE DRIVING ON THE INTERSTATE THE OWNER SAW THE ABS LIGHT COME ON AND DIDN'T KNOW WHAT IT WAS. (2 more)
    Remedy
    THE MECHANIC UNHOOKED THE ABS MOTOR.