Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightMisfire or rough idleLoss of engine power, no accelerationLeakNoiseGauge or instrument faultHard start or long crankDoes not start

Possible causes

Warning light, Check engine / Service Engine Soon66 records
Engine
Exhaust and emissions
Electrical, wiring and power
Heating and air conditioning
Instruments and lighting
Brakes
6Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring1Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only1Engine Valve: clogged or contaminated0Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)5P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)1Purge Solenoid: failed1Oxygen Sensor: failed1Reduced Engine Power from throttle body connector crimp, broken wire or grounds1Rear Window Defroster Contact: broken0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion1Seat Heater: overheated1Instrument panel cluster gauges stick, flutter or stop working0CHECK OIL LEVEL message stays on after an oil change or top-off until the engine cools0Brake pipe (brake line) corrosion and rupture0ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)0Front right-hand brake pipe contact with body cross sill - recall 00V-3450Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)0Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)
10 causes not drawn
Causes with no correction stated (10)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Airbags and seat belts
Airbag: failed (1)
Exhaust and emissions
Evap Vent Valve: clogged or contaminated (1)Exhaust Manifold Bolt: broken (1)Secondary Air Injection Valve: corroded (1)
Fuel system
Fuel Tank: leaking (1)
Electrical, wiring and power
Powertrain Control Module: software (1)TAC Module: electrical fault (1)Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
Transmission and driveline
Transmission Range Switch: failed (1)
Brakes
Service Stability message with DTC C0131, C0196, C0290 and/or C0292 (0)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon 2000–2006・Warning light, Check engine / Service Engine Soon

Candidate cause (named by records only; no technical document)

Oxygen Sensor: failed

1 of the records matching this search name this component as the cause.

How to tell

Check engine / Service Engine Soon

What to do

No technical document states a check or a repair.

In the records

  • Oxygen Sensor: replaced 1
See the evidence (0 technical documents, 1 records)

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.