Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

Common on this vehicle:Gauge or instrument faultNoiseWarning lightCorrosion or rustLeakReduced brakingAir conditioning or heaterVibration or shudder

Possible causes

Warning light238 records
Engine
Brakes
Exhaust and emissions
Fuel system
Airbags and seat belts
Suspension, wheels and tires
9Intake manifold gasket leak (cold idle misfire, lean codes)7Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring2Throttle Body1DTCs P2108, P1516 and U0107 (do not replace the TAC module)1P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1Rear bank knock sensor corrosion from water intrusion (P0332)9Brake pipe (brake line) corrosion and rupture4Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)1Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)1Stability System Disabled / Service Stability message with DTC C0455 (bent terminals at the steering wheel position sensor)1Electronic Brake Control Module1Stabilitrak System0Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)5P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)1Purge Solenoid1Oxygen Sensor3DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)2Seat Belt Buckle1Air bag lamp on with DTC B0092 (passenger presence system sensor harness)1SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)1Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1Seat Belt Warning Light1Seat Belt2Autoride (Z55) Service Ride Control / Service Suspension System message2Aluminum Wheel Bead Seat1Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-106
23 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)

The Driver Information Center (DIC) may display the Stability System Disabled message.

Other concerns are unwanted Stabilitrak activation, noticeable dimming of the vehicle lighting systems, and the VSES motor coming on unexpectedly.

How to tell

Stability control message (StabiliTrak)

What to do

  1. Check for excessive wear on the tires and verify that all the tires are the same size, brand and model.

In the records

No record states work done for this cause.

See the evidence (1 technical documents, 0 records)

Passages of the technical documents

  • This information applies to the 2002-06 Cadillac Escalade, Chevrolet Avalanche, Suburban, Tahoe, GMC Yukon and Denali with RPO JL4.

    General Motors 2006-07-01

  • - Stability System Disabled message displayed on the Driver Information Center (DIC)

    General Motors 2006-07-01

  • - unwanted Stabilitrak activation - vehicle lighting systems may dim noticeably - VSES motor may come on unexpectedly

    General Motors 2006-07-01

  • The following examples could cause any of the conditions listed above. - two tires on the vehicle are brand new and the other two tires have excessive wear

    General Motors 2006-07-01

Read every statement and its source →

Records

None among the records that can be opened now.

See all 0 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.