Skip to content
FaultCrate
日本語Open preview: everything readable

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightLoss of engine power, no accelerationStalls or shuts offMisfire or rough idleLeakNoiseGauge or instrument faultDoes not start

Possible causes

Stalls or shuts off, Engine40 records
Engine
Electrical, wiring and power
Fuel system
4Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only1Ignition Coil: failed0Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)1Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Passlock theft deterrent: starts then stalls / no-start with security lamp0Out of fuel with the gauge reading above empty, cranks but no start, stall (replace the fuel sensor, not the sender module)0Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1551500 only0Engine fuel rail crossover tube retainer screws may break (5.3L RPO L59) - recall 04V-3765.3L only
Causes with no correction stated (8)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Fuel system
Fuel Pump: failed (1)
Electrical, wiring and power
Ignition Switch: failed (1)
Instruments and lighting
Instrument Panel Cluster: failed (1)
Engine
Intake Manifold: overheated (1)Timing Belt: broken (1)
Body, doors and interior
Rear Wiper: failed (1)
Brakes
Wheel Speed Sensor: corroded (1)Wheel Speed Sensor Mounting Surface: clogged or contaminated (1)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

FaultCrate・GMC Yukon XL 2000–2006・Stalls or shuts off, Engine

Candidate cause (the documents say what to do)

Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-521

Applies to: 8.1L only

The crankshaft position can operate intermittently or fail completely.

With intermittent operation the SES light may illuminate and the vehicle may run rough.

How to tell

Check engine / Service Engine Soon

What to do

  1. Dealers replace the crankshaft position sensor.
  2. As the remedy, an improved CKP is installed.
  3. The repair listed for the claim is: replace the crankshaft position sensor and perform the Crankshaft Position System Variation Learn.
  4. Part: 12575172 Sensor, Crankshaft Position, quantity 1 per vehicle.

Caution: All of the surveyed consumers noted multiple stalling events before the CKP was properly diagnosed and replaced.

What is needed

Parts and materials
  • Crankshaft position sensor 12575172 (quantity 1 per vehicle)

Part numbers printed in the document

The numbers are as the document prints them. The name and the replacing number are what the pages of GMPartsGiant, a reseller of genuine parts and not GM, state. Aftermarket equivalents are not checked here (the links only search by number). Confirm the fit for the vehicle (VIN) before ordering.

Labor time
Not stated
Special tools
Not stated
Scan tool
  • Crankshaft Position System Variation Learn

Only what the technical documents state. "Not stated" does not mean not needed.

In the records

  • Crankshaft Position Sensor: replaced 1（says it was fixed: 1）
  • Transmission: repaired 1（result not stated: 1）
See the evidence (1 technical documents, 4 records)

Passages of the technical documents

  • The recall text refers to pickup trucks with an 8.1L V8 engine.

    ON CERTAIN PICKUP TRUCKS EQUIPPED WITH AN 8.1L V8 ENGINE,

    NHTSA 2007-11-07

  • The crankshaft position can operate intermittently or fail completely.

    THE CRANKSHAFT POSITION CAN OPERATE INTERMITTENTLY OR FAIL COMPLETELY.

    NHTSA 2007-11-07

  • With intermittent operation the SES light may illuminate and the vehicle may run rough.

    IF THE SENSOR OPERATES INTERMITTENTLY, THE SES LIGHT MAY ILLUMINATE AND THE VEHICLE MAY RUN ROUGH.

    NHTSA 2007-11-07

  • The engine may stall and may restart immediately or after a cool-down period.

    THE ENGINE MAY STALL, AND IF SO, MAY RE-START IMMEDIATELY OR AFTER A COOL DOWN PERIOD.

    NHTSA 2007-11-07

Read every statement and its source →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.

Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.