Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

Common on this vehicle:Warning lightMisfire or rough idleLoss of engine power, no accelerationStalls or shuts offLeakNoiseGauge or instrument faultHard start or long crank

Possible causes

Smoke or fire, Check engine / Service Engine Soon3 records
Exhaust and emissions
Fuel system
Brakes
Electrical, wiring and power
Engine
Heating and air conditioning
1Purge Solenoid: failed0P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)1Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1551500 only0Aftermarket part (not the vehicle as built): Fram G3727 replacement fuel filter connector - recall 06E-0430Engine fuel rail crossover tube retainer screws may break (5.3L RPO L59) - recall 04V-3765.3L only0Engine fuel rail pulse damper retainer clip may fracture (8.1L V8) - recall 06V-289 / Transport Canada 20061958.1L only0DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)0Hydro-boost brake assist and power steering share one hydraulic supply (four campaigns)0Intermittent MIL, service lamps/messages or DTCs from connector fretting corrosion0Positive battery cable contact with steering shaft universal joint (Denali) - Transport Canada 20010920Reduced Engine Power from throttle body connector crimp, broken wire or grounds0Conversion equipment (not the vehicle as built): Southern Comfort running board courtesy lights overheating - recall 03V-0940Crankshaft position sensor may work intermittently or fail (8.1L V8) - recall 07V-5218.1L only0Intake manifold gasket leak (cold idle misfire, lean codes)0Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring0P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)0Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only0HVAC blower motor resistor module / connector overheating
1 causes not drawn

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Purge Solenoid: failed

1 of the records matching this search name this component as the cause.

How to tell

P0442Check engine / Service Engine Soon

What to do

No technical document states a check or a repair.

In the records

  • Purge Solenoid: replaced 1
See the evidence (0 technical documents, 1 records)

Records

None among the records that can be opened now.

See all 1 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.