Manufacturer communication — 2006 GMC YUKON DENALI XL

Fitment confirmedReporter type: ManufacturerEQUIPMENT

Relation to the target vehicle

The source's vehicle field includes the trim.

Model year: Match 2006 — Source vehicle field
Model: Match YUKON DENALI XL — Source vehicle field
Trim: Match Denali — Source vehicle field

What the manufacturer’s document says

02-08-98-002D ・ information ・ for GM vehicles in general

Applies to

2013 and prior GM passenger cars and trucks.
the passage
Models: 2013 and Prior GM Passenger Cars and Trucks

Fault

For hem flange corrosion, Kent Moore tool J-46162 makes it easier to open the hem flange.
the passage
In the event that hem flange corrosion becomes a concern, a new tool has been released by Kent Moore, J-46162, which allows for easier opening of the hem flange.

Correction

Repair

Fit the tool from kit J-46162 into an air impact gun and open the hem flange starting at one end.
the passage
3. Using Kit J-46162, insert the tool into an air impact gun and open the hem flange up starting at one end.
Clean out the corrosion by sand blasting or with a 3M Strip Disc, P/N 07460.
the passage
4. Clean out the corrosion by “sand blasting” or by using *3M® Strip Disc, P/N 07460.
Apply anticorrosion primer to the hem flange, then a bead of LORD FUSOR adhesive, P/N 108B or 109B.
the passage
6. Apply anticorrosion primer to the hem flange. 7. Apply a bead of *LORD FUSOR, P/N 108B or 109B, adhesive to the hem flange.
Close the hem flange with the tool in the kit and clean off the excess adhesive from the repair area.
the passage
8. Close the hem flange using the tool in the kit. 9. Clean off excessive adhesive from the repair area.
Finally prime and refinish the area as required.
the passage
Prime and refinish the area as required.

Caution

If perforation is present, replace the affected panel.
the passage
Important: If perforation is present, replace the affected panel.

Compiled by reading the full text of the document; each point stands on the passage shown. Check the document itself, linked below, before working on a vehicle.

Stated content

Communication summary
本情報通知は、2010-2013年モデルを追加し、承認された再仕上げ材料の小冊子情報を改訂するために、02-08-98-002Cの改訂版である。 Machine translation (unreviewed)
This informational bulletin provides a revision for 02-08-98-002C to add the 2010-2013 model years and revise the Approved Refinish Materials booklet information.
Go to this passage in the original

Source

Source: NHTSA Manufacturer Communications
Source reference: 10139059
Received by source: 2018-06-04
Incident date: Unknown

Open original text and source Open the provider's page (external)