Skip to content
FaultCrate

This is an open preview: every record can be read without an account. The details of the plans are in preparation.

GMC Yukon 2000–2006

GMC YukonModel years 2000–2006

Change vehicle →
Clear the search
1 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightNoiseLeakGauge or instrument faultMisfire or rough idleVibration or shudderCorrosion or rustAir conditioning or heater

Possible causes

2005990 records
Instruments and lighting
Brakes
Exhaust and emissions
Engine
Steering
Electrical, wiring and power
26Instrument panel cluster gauges stick, flutter or stop working10Shift lever position indicator in the instrument cluster may not illuminate (FMVSS 102) - recall 05V-0556Speedometer needle appears inaccurate (specification +/- 2 MPH)4Voltmeter fluctuates between 12 and 14 volts (Regulated Voltage Control, normal)1CHECK OIL LEVEL message stays on after an oil change or top-off until the engine cools10Brake pipe (brake line) corrosion and rupture5Hydro-boost brake assist and power steering share one hydraulic supply (four campaigns)2ABS light with C0265/C0201/U1041 or no communication with brake module (EBCM ground G110)1Unwanted ABS activation at low speed (front wheel speed sensor mounting corrosion)1Brake pedal pushrod retainer missing - recall 05V-10310Exhaust pop or ping noise (replace the heat shield, not the exhaust system)5P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)1Purge Solenoid: failed1Oxygen Sensor: failed7Single-cylinder misfire (P0300-P0308) and/or chirp, squeak or tick at camshaft speed: worn cam lobe / lifter, valve or valve spring5Engine Block4Oil leak after cold start from frozen PCV system (rear main seal)1Castech cylinder head porosity crack (gradual coolant loss)4.8L, 5.3L only1Engine vibration or noise at idle felt in the steering wheel or seat (reprogram the PCM)4Steering intermediate shaft clunk1Power steering pump whine between idle and 2000 rpm1Quadrasteer: rear wheels stay turned after the front wheels are straight (controlled re-centering after a fault, normal operation)1Tire scrub noise on low speed turns (steering rod / centerlink installed backwards)3Ground Ring Terminal: loose or misadjusted2Adjustable pedals do not recall preset positions and/or front heated seats turn off after 30 seconds (brake pedal position switch)2CD slow to play, CHECK CD error, CD stuck or clock resets to 12:00 (reprogram the radio, do not replace it)2Intermittent stall, misfire or crank no start (Ignition 1 feed wire broken near C148/C149)2Rear seat audio and/or rear HVAC controls inoperative (replace the RSA, not the console)
62 causes not drawn
Causes with no correction stated (34)

Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.

Airbags and seat belts
Airbag Sensor: failed (2)
Audio and telematics
CD Changer: failed (1)

The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.

Candidate cause (the documents say what to do)

Engine Block

5 of the records matching this search name this component as the cause.

What to do

No technical document states a check or a repair.

In the records

No record states work done for this cause.

See the evidence (0 technical documents, 5 records)

Records

None among the records that can be opened now.

See all 5 records of this cause →

A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.