GMC Yukon 2000–2006
Common on this vehicle:Gauge or instrument faultWarning lightNoiseLeakMisfire or rough idleAir conditioning or heaterCorrosion or rustVibration or shudder
Possible causes
20041,161 records
Instruments and lighting
Brakes
Exhaust and emissions
Electrical, wiring and power
Engine
Audio and telematics
9861124107211352112321197544322111155 causes not drawn
- Service Brake Booster message on a Hydroboost vehicle with DTC C0136 (instrument cluster not SPS programmed)1
- Stability System Disabled message and unwanted StabiliTrak activation (tire wear or mismatched tires)1
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement1
- Radio shows a disc error when a media disc is inserted (unsupported disc format or damaged disc)1
- No audio and no radio display, or radio clock resets (2004; radio set-up with the Tech 2)1
- Red radio theft LED does not flash (manufacturer's counter not reset at assembly)1
- Reduced Engine Power from throttle body connector crimp, broken wire or grounds1
- DRLs or auto headlamps will not disable with the headlamp switch (Canada, RPO Z49; normal)1
- Hum or fan noise from the navigation radio (internal cooling fan, normal)1
- Radio volume lower at the same setting after reprogramming or replacement (new audio calibration, normal)1
- Engine vibration or noise at idle felt in the steering wheel or seat (reprogram the PCM)1
- P0300 after engine repairs: injector connectors crossed (cylinders 5-7 / 6-8)1
- Slight roughness at idle with no DTCs (possible characteristic)1
- HVAC blower motor resistor module / connector overheating3
- No passenger compartment air filter (not available from the 2003 model year; normal)2
- Climate Control Module2
- HVAC actuator clicking / ticking noises (recalibrate the HVAC control module, do not replace actuators)1
- Rear HVAC ticking noise, no rear temperature or mode control, DTC B0434 / B3764 (revised auxiliary HVAC control module)1
- Autoride (Z55) Service Ride Control / Service Suspension System message3
- Vehicle body tilt or lean left / right (torsion bar front suspension)3
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1061
- Grease seen at front hub bearing seals (normal purge, do not replace)1
- Upper control arm bracket alignment (dowel) pin missing at front end alignment1
- Headliner sagging (hook and loop patch detached; reattach with epoxy)2
- Bench seat (RPO AE7) center console armrest hinges broken (replace the lid, not the console assembly)1
- Center console cupholder and ashtray lid will not close (Denali; latch pulled out of its retainer)1
- Door sags or is hard to open or close (worn or corroded hinge pins and bushings)1
- Snap or popping noise from the front of the vehicle (slot the front crossmember mounting holes)1
- Front seat adjuster switch knob loose or missing (replace only the switch cover)1
- Stains on the rear bumper step pad (treat with Armor-Dillo, do not replace)1
- Double vision or ghost image in the driver's auto dimming outside mirror (normal)1
- 4L60-E burnt 3-4 clutch pack2
- 4L60-E slip or no forward engagement right after input housing replacement (service part 17803687)1
- 4L80-E / 4L85-E planetary gear whine in first and second gear1
- 4WD/AWD lamps and system inoperative: "sleepy" New Venture Gear transfer case control module (reprogram the TCCM)1
- Electronic transfer case stops shifting with no DTC (shift abuse lock out mode, normal)1
- Transfer case speed sensor connector locks bend on disconnect (improved connector)1
- Grind / ratchet noise when shifting into Park in 4LO (characteristic)1
- Axle1
- Aftermarket part (not the vehicle as built): Fram G3727 replacement fuel filter connector - recall 06E-0431
- Fuel gauge reads low or drops to empty in Park / Neutral (normal characteristic)1
- Out of fuel with the gauge reading above empty, cranks but no start, stall (replace the fuel sensor, not the sender module)1
- Fuel Line2
- Fuel Pump2
- Fuel Pump Module2
- Seat Belt Buckle2
- 2nd row center seat belt routing (lap belt fit) - recall 05V-1631
- SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)1
- Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement1
- Seat Belt Warning Light1
- Steering intermediate shaft clunk2
- Power steering pump whine between idle and 2000 rpm1
- Quadrasteer: rear wheels stay turned after the front wheels are straight (controlled re-centering after a fault, normal operation)1
- Tire scrub noise on low speed turns (steering rod / centerlink installed backwards)1
- Steering Gear Box1
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon 2000–2006・2004
Candidate cause (the documents say what to do)
Instrument panel cluster gauges stick, flutter or stop working
Customers reported that one or more instrument cluster gauges stick, flutter or become inoperative.
What to do
- Dealers replace the instrument panel cluster after verifying the condition.
In the records
- Instrument Panel Cluster: replaced 2（says it came back: 1, result not stated: 1）
- Instrument Panel Cluster: repaired 1（says it was fixed: 1）
See the evidence (1 technical documents, 98 records)
Passages of the technical documents
2003-2004 GMC SIERRA, YUKON, YUKON XL
Anthony's Cluster Repair (repair-shop web page reproducing GM bulletin 07187C; not GM-hosted) 2009-03-20
2005 GMC SIERRA, YUKON, YUKON XL (U.S. ONLY)
Anthony's Cluster Repair (repair-shop web page reproducing GM bulletin 07187C; not GM-hosted) 2009-03-20
have reported that one or more of the instrument panel (IP) cluster gauges stick, flutter, or become inoperative.
Anthony's Cluster Repair (repair-shop web page reproducing GM bulletin 07187C; not GM-hosted) 2009-03-20
This may cause inaccurate readings, including the speedometer and fuel gauge.
Anthony's Cluster Repair (repair-shop web page reproducing GM bulletin 07187C; not GM-hosted) 2009-03-20
Records
- Multiple electrical and mechanical failures including gauge failure, brake issues, and more Owner complaint 2015-02-27
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.