GMC Yukon XL 2000–2006
Common on this vehicle:Gauge or instrument faultWarning lightLoss of engine power, no accelerationSmoke or fireAir conditioning or heaterStalls or shuts offLeakDoes not start
Possible causes
10 causes not drawn
- Rear bank knock sensor corrosion from water intrusion (P0332)4.8L, 5.3L, 6.0L only0
- Throttle body carbon build-up: idle surge, reduced engine power, throttle DTCs (high mileage)0
- ABS lamp with DTC C0265 (EBCM motor relay circuit) after EBCM replacement0
- P0420 / P0430 on a new or just-replaced catalytic converter (break-in not completed)0
- Fuel module reservoir assembly: fuel pump wire connectors may overheat - recall 05V-1551500 only0
- DTC P0446 set with the SES lamp on (replace the EVAP vent solenoid, not the canister)0
- SIR lamp on and inside mirror temperature/compass display inoperative (open air bag fuse, circuit 1139 shorted to ground)0
- Air bag (SIR) lamp on with DTC B1001 after BCM or SDM replacement0
- Autoride (Z55) Service Ride Control / Service Suspension System message0
- Aftermarket part (not the vehicle as built): Federal-Mogul National / Carquest replacement wheel hub assembly retention nut - recall 07E-1062WD only0
Causes with no correction stated (6)
Causes the records name for which no check or repair is stated, in a technical document or in a record. Press one for the records that name it.
- Fuel system
- Fuel Pump Wiring: overheated (1)
- Electrical, wiring and power
- Ignition Circuit Or Ground Wire: electrical fault (1)Pass-Through Connector: broken (1)Intermittent no start with Service Stability, ABS light, 'Unknown Driver' and multiple DTCs / no module communication (0)
- Body, doors and interior
- Seat Position Sensor: broken (1)
The documents say what to doOnly records name itThe size of a node, the width of a link and the numbers are records matching this search, not likelihoods.
FaultCrate・GMC Yukon XL 2000–2006・Warning light, Electrical, wiring and power
Candidate cause (the documents say what to do)
Vehicle Communication Interface Module: electrical fault, software
2 of the records matching this search name this component as the cause.
How to tell
B2455
What to do
- Pull back the tape at X2 of the VCIM far enough to see where the bare wires are covered.
- Tape the bare wires individually to prevent them from shorting, then tape the harness back up.
- The warranty labor operation is 602058, Onstar Upgrade Wire Repair.
What is needed
- Parts and materials
- Not stated
- Labor time
- 602058: Onstar Upgrade Wire Repair, .3 Hr
- Special tools
- Not stated
- Scan tool
- Not stated
Only what the technical documents state. "Not stated" does not mean not needed.
In the records
- Vehicle Communication Interface Module: repaired 1
See the evidence (2 technical documents, 2 records)
Manufacturer’s documents
- Telematics Communication Interface Control Module DTC B101D Notice PIT5236K 2019-04-08
- Vehicle Communication Interface Module LED and DTC B2455 Issue PIC6140A 2017-08-15
A cause or a result a complaint states is the owner’s view or what a dealer told them, not an established fact.
Put together by FaultCrate from public records and technical documents. The cause and the repair are for the workshop to decide with the vehicle in front of it. Counts are records, not failure rates.