Skip to content
FaultCrate
日本語

This is an open preview: every record can be read without an account.

GMC Yukon XL 2000–2006

GMC Yukon XLModel years 2000–2006

Change vehicle →
Clear the search
2 conditions added

The vehicle (where a record says)

A record is under an engine, a drive or a series only where it says so: the characters of the vehicle identification number filed with a complaint, its text, or what its document says it applies to. A record that does not say is kept as "not stated". The filed numbers and the documents do not tell 4WD from AWD.

Common on this vehicle:Warning lightLoss of engine power, no accelerationStalls or shuts offMisfire or rough idleLeakNoiseGauge or instrument faultDoes not start

Record by record

3 records state a cause or a remedy. Each record is shown as short labels in the order fault → finding the cause → correction. Press a label to narrow to the records that state it.

Read the records one by one (3)

ENGINE AND ENGINE COOLING2

  1. Manufacturer communication2004–2006 GMC YUKON XL 2500 ・ 2023-11-22

    Vibration Analysis Worksheet Service Bulletin

    1. 1Fault

    2. 2Finding the cause

      Steps to confirm (in the document’s order)

      1. When diagnosing vibration, use the worksheet together with the Vibration Analysis - Road Testing procedure in the service information.
      2. Place the sensor where the vibration is felt: on the seat track for a seat complaint, on the steering column for a steering wheel complaint.
      3. Moving the sensor to other areas, look for the same Hz reading with the greatest amplitude.
      4. If a system balance was attempted and the vibration remains, check ring gear backlash at each tooth; readings should not vary more than 0.050 mm (0.002 in).
      5. Aluminum wheel/tire runout measured on the vehicle: maximum 0.030 in (.762 mm).
      2 more points

    3. 3Correction

      This service bulletin provides a vibration analysis worksheet the technician can use in conjunction with the appropriate Vibration Analysis-Road testing procedure when diagnosing vibration concerns.

    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to 2024 and prior GM passenger cars and trucks.
    • Confirm：When diagnosing vibration, use the worksheet together with the Vibration Analysis - Road Testing procedure in the service information.
    • Confirm：Place the sensor where the vibration is felt: on the seat track for a seat complaint, on the steering column for a steering wheel complaint.
    • Confirm：Moving the sensor to other areas, look for the same Hz reading with the greatest amplitude.
    • Confirm：If a system balance was attempted and the vibration remains, check ring gear backlash at each tooth; readings should not vary more than 0.050 mm (0.002 in).
    • Confirm：Aluminum wheel/tire runout measured on the vehicle: maximum 0.030 in (.762 mm).
    • Confirm：Hub mounting surface runout: maximum 0.005 in (0.132 mm).
    • Confirm：Wheel stud runout: maximum 0.010 in (0.254 mm).

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This service bulletin provides a vibration analysis worksheet the technician can use in conjunction with the appropriate Vibration Analysis-Road testing procedure when diagnosing vibration concerns.

  2. Manufacturer communication2001–2006 GMC YUKON XL ・ 2018-06-04

    Engine Squealing Type Noise on Start-up or Vibration

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3Correction

      Repair

      • Inspect the crankshaft balancer for an outer ring slipping on the center hub; if found, replace the crankshaft balancer.
    Read the sentences of the record

    From the manufacturer’s document

    • Applies to：Applies to the listed models equipped with the 3.5L or 3.9L engine (RPOs LZ4, LZE, LZ8, LGD, LZ9, LZG, LX9).
    • Repair：Inspect the crankshaft balancer for an outer ring slipping on the center hub; if found, replace the crankshaft balancer.

    Open the manufacturer’s document (PDF) ↗ The points above were read from this document.

    Remedy
    This informational bulletin provides information for Engine Squealing Type Noise on Start-up or Vibration Condition.

ELECTRONIC STABILITY CONTROL (ESC)1

  1. Owner complaint2004 GMC YUKON XL 1500 ・ 2016-01-06

    Engine stall and loss of power while driving at 60 MPH

    1. 1Fault

    2. 2Finding the cause

      Not stated

    3. 3CorrectionNot repaired

      THE VEHICLE WAS NOT REPAIRED.

    Read the sentences of the record
    Fault
    THE ENGINE STALLED AND LOST POWER. (1 more)
    Remedy
    THE VEHICLE WAS NOT REPAIRED.
    Inspection
    THE VEHICLE WAS TAKEN TO A LOCAL DEALER WHO WAS UNABLE TO DUPLICATE AND DIAGNOSE THE FAILURE.